Frigidaire Factory Service ManualFault Code: E47

Frigidaire Washer Error Code E47: PTC Door Lock Circuit Open / Thermistor Failure

The main control board attempts to energize the door lock mechanism but detects an open circuit in the PTC lock solenoid loop.

Target Appliance

washer

OEM Certified Technical Diagnostic Tree

Diagnostic Tool Required

Digital Multimeter

Measure Ohms resistance, continuity & line voltage.

Triage Complexity

Advanced Diagnostic

4 Sequential manufacturer inspection branches.

Sequential Factory Diagnostic Tree

Perform each diagnostic step in order. Disconnect electrical power and turn off utility shutoffs before inspecting wiring or internal mechanical assemblies.

Step 1: Physical & Electrical InspectionMultimeter & Visual

Action: Disconnect power, remove door bellows clamp, and extract door lock mechanism from front panel.

Bench Test: Inspect the multi-pin connector plug for moisture corrosion or loose terminal pins.

Expected Standard: Dry, corrosion-free contacts.

If Failed / Out of Spec:

Clean contacts or replace connector plug.

If Passed:

Proceed to Step 2.

Step 2: Physical & Electrical InspectionMultimeter & Visual

Action: Measure resistance across the door lock PTC circuit terminals with a multimeter.

Bench Test: Check resistance across lock pins 1 and 3.

Expected Standard: 1,100 to 1,500 ohms at room temperature.

If Failed / Out of Spec:

Resistance reads open circuit (0L). Replace door lock assembly (134629900).

If Passed:

Proceed to Step 3.

Step 3: Physical & Electrical InspectionMultimeter & Visual

Action: Test continuity across harness wires between door lock and main control board.

Bench Test: Perform wiggle test on harness leads while monitoring continuity beeper on multimeter.

Expected Standard: Continuous 0 ohms without intermittent drops.

If Failed / Out of Spec:

Repair broken wire strand inside harness jacket.

If Passed:

Proceed to Step 4.

Step 4: Physical & Electrical InspectionMultimeter & Visual

Action: Test control board output voltage to door lock during cycle initiation.

Bench Test: Measure AC voltage pulse delivered to lock terminals at start of cycle.

Expected Standard: 120V AC pulse applied for 3 to 5 seconds.

If Failed / Out of Spec:

Replace main electronic control board (137006000).

If Passed:

Replace door lock assembly (134629900).

Verified OEM Replacement Parts

Cross-referenced factory part numbers for Frigidaire washer error code E47. Always replace defective components with authentic OEM parts to maintain UL safety certification.

Component Name	OEM Part Number	Manufacturer	Status
Door Lock Mechanism Assembly	`134629900`	Frigidaire	Direct Fit OEM
Main Electronic Control Board	`137006000`	Frigidaire	Direct Fit OEM
Front Door Bellows Retaining Spring Clamp	`134527100`	Frigidaire	Direct Fit OEM

Need Local Diagnostic Assistance?

Connect with a Certified Frigidaire Technician in Your Area

If multimeter testing reveals an internal short, locked motor, or fried control board, let an experienced local technician complete the repair with certified OEM replacement parts.

Call for Immediate Technician Dispatch Search Another Code

Frequently Asked Questions: Frigidaire E47

What causes Frigidaire washer error code E47?

The main control board attempts to energize the door lock mechanism but detects an open circuit in the PTC lock solenoid loop.

Can I reset the E47 code by unplugging the washer?

While disconnecting power for 5 minutes may temporarily clear the display control memory, the E47 code will reoccur once the microcontroller detects the mechanical or electrical fault again.

What OEM replacement parts are required for Frigidaire E47?

Common OEM replacement components include: Door Lock Mechanism Assembly (OEM #134629900), Main Electronic Control Board (OEM #137006000), Front Door Bellows Retaining Spring Clamp (OEM #134527100).