Frigidaire Factory Service ManualFault Code: E41

Frigidaire Washer Error Code E41: Door Switch Open / Door Latch Not Sensing Closure

The main control board senses that the front door switch contacts are open when a wash cycle is commanded to start.

Target Appliance

washer

OEM Certified Technical Diagnostic Tree

Diagnostic Tool Required

Digital Multimeter

Measure Ohms resistance, continuity & line voltage.

Triage Complexity

Advanced Diagnostic

4 Sequential manufacturer inspection branches.

Sequential Factory Diagnostic Tree

Perform each diagnostic step in order. Disconnect electrical power and turn off utility shutoffs before inspecting wiring or internal mechanical assemblies.

Step 1: Physical & Electrical InspectionMultimeter & Visual

Action: Inspect front door striker latch and door alignment.

Bench Test: Check if plastic door latch prong on door edge is broken, bent, or failing to enter door lock aperture fully.

Expected Standard: Door strike latch rigid, straight, and enters lock mechanism squarely.

If Failed / Out of Spec:

Replace door strike latch bracket (134456600).

If Passed:

Proceed to Step 2.

Step 2: Physical & Electrical InspectionMultimeter & Visual

Action: Inspect door lock switch assembly mounted inside front cabinet panel.

Bench Test: Disconnect door lock wire harness and measure continuity across door switch terminals with door closed.

Expected Standard: 0 ohms (continuity) when latch engages switch; infinity when door is open.

If Failed / Out of Spec:

Switch internal contacts burned or stuck open. Replace door lock assembly (134629900).

If Passed:

Proceed to Step 3.

Step 3: Physical & Electrical InspectionMultimeter & Visual

Action: Inspect wire harness between door lock assembly and main control board.

Bench Test: Test continuity across each wire in the door lock harness bundle.

Expected Standard: 0 ohms continuity; zero rubbed or pinched wires near tub vibration zone.

If Failed / Out of Spec:

Repair harness wiring or replace door lock wiring pigtail.

If Passed:

Proceed to Step 4.

Step 4: Physical & Electrical InspectionMultimeter & Visual

Action: Inspect main electronic control board door sensing input circuit.

Bench Test: Verify 120V AC input signal at control board terminal J4 during door closure.

Expected Standard: Normal input voltage signal present.

If Failed / Out of Spec:

Replace main electronic control board (137006000).

If Passed:

Reassemble and verify cycle start.

Verified OEM Replacement Parts

Cross-referenced factory part numbers for Frigidaire washer error code E41. Always replace defective components with authentic OEM parts to maintain UL safety certification.

Component Name	OEM Part Number	Manufacturer	Status
Door Lock & Latch Switch Assembly	`134629900`	Frigidaire	Direct Fit OEM
Door Striker Latch Prong	`134456600`	Frigidaire	Direct Fit OEM
Main Electronic Control Board	`137006000`	Frigidaire	Direct Fit OEM

Need Local Diagnostic Assistance?

Connect with a Certified Frigidaire Technician in Your Area

If multimeter testing reveals an internal short, locked motor, or fried control board, let an experienced local technician complete the repair with certified OEM replacement parts.

Call for Immediate Technician Dispatch Search Another Code

Frequently Asked Questions: Frigidaire E41

What causes Frigidaire washer error code E41?

The main control board senses that the front door switch contacts are open when a wash cycle is commanded to start.

Can I reset the E41 code by unplugging the washer?

While disconnecting power for 5 minutes may temporarily clear the display control memory, the E41 code will reoccur once the microcontroller detects the mechanical or electrical fault again.

What OEM replacement parts are required for Frigidaire E41?

Common OEM replacement components include: Door Lock & Latch Switch Assembly (OEM #134629900), Door Striker Latch Prong (OEM #134456600), Main Electronic Control Board (OEM #137006000).