Bosch Factory Service ManualFault Code: E10

Bosch Refrigerator Error Code E10: Main Power Control & Display Communication Loss

The door-mounted user interface display panel has lost serial communication with the master inverter power control module in the machine compartment.

Target Appliance

refrigerator

OEM Certified Technical Diagnostic Tree

Diagnostic Tool Required

Digital Multimeter

Measure Ohms resistance, continuity & line voltage.

Triage Complexity

Advanced Diagnostic

4 Sequential manufacturer inspection branches.

Sequential Factory Diagnostic Tree

Perform each diagnostic step in order. Disconnect electrical power and turn off utility shutoffs before inspecting wiring or internal mechanical assemblies.

Step 1: Physical & Electrical InspectionMultimeter & Visual

Action: Inspect top door hinge wire harness cover and door wiring conduit.

Bench Test: Check bundle of multi-conductor wires running through top door hinge for pinching or cut insulation.

Expected Standard: Harness intact, zero broken copper strands inside insulation jacket.

If Failed / Out of Spec:

Repair broken wire strands with insulated solder sleeves or replace door harness.

If Passed:

Proceed to Step 2.

Step 2: Physical & Electrical InspectionMultimeter & Visual

Action: Unplug and reseat display board molex connectors on user interface panel.

Bench Test: Check male and female pins for backed-out terminals or green copper corrosion.

Expected Standard: All pins fully locked in housing with clean contacts.

If Failed / Out of Spec:

Reseat pins or replace connector plug.

If Passed:

Proceed to Step 3.

Step 3: Physical & Electrical InspectionMultimeter & Visual

Action: Measure DC supply voltage from main control board to display panel.

Bench Test: Measure DC voltage between VCC and GND pins at the display harness connector.

Expected Standard: Steady 12V DC power supplied from main board.

If Failed / Out of Spec:

Replace master electronic power control module (11020478).

If Passed:

Proceed to Step 4.

Step 4: Physical & Electrical InspectionMultimeter & Visual

Action: Test serial TX/RX communication bus with an oscilloscope or digital multimeter set to DC volts.

Bench Test: Check for active fluctuating data pulses (typically 2.5V to 4.8V).

Expected Standard: Continuous high-speed data transmission.

If Failed / Out of Spec:

Replace front door display interface board (11028755).

If Passed:

Replace master power module (11020478).

Verified OEM Replacement Parts

Cross-referenced factory part numbers for Bosch refrigerator error code E10. Always replace defective components with authentic OEM parts to maintain UL safety certification.

Component Name	OEM Part Number	Manufacturer	Status
User Interface Touch Display Board	`11028755`	Bosch	Direct Fit OEM
Master Inverter Power Control Module	`11020478`	Bosch	Direct Fit OEM
Upper Door Hinge Wire Harness Assembly	`00658421`	Bosch	Direct Fit OEM

Need Local Diagnostic Assistance?

Connect with a Certified Bosch Technician in Your Area

If multimeter testing reveals an internal short, locked motor, or fried control board, let an experienced local technician complete the repair with certified OEM replacement parts.

Call for Immediate Technician Dispatch Search Another Code

Frequently Asked Questions: Bosch E10

What causes Bosch refrigerator error code E10?

The door-mounted user interface display panel has lost serial communication with the master inverter power control module in the machine compartment.

Can I reset the E10 code by unplugging the refrigerator?

While disconnecting power for 5 minutes may temporarily clear the display control memory, the E10 code will reoccur once the microcontroller detects the mechanical or electrical fault again.

What OEM replacement parts are required for Bosch E10?

Common OEM replacement components include: User Interface Touch Display Board (OEM #11028755), Master Inverter Power Control Module (OEM #11020478), Upper Door Hinge Wire Harness Assembly (OEM #00658421).